- ページ 25
タブレット Fujitsu Point 1600のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu Point 1600 48 ページ。 Pen tablet
Fujitsu Point 1600 にも: 製品リファレンス (2 ページ)
![Fujitsu Point 1600 ユーザーマニュアル](/uploads/products/server2/2461136/2461136.png)
Charging the Battery Pack (While Installed in the Pen Tablet)
The Point 1600 battery pack can be charged while it is installed in the Point 1600 pen
tablet. To charge the battery pack,
1. Look at the Low-Battery LED while the pen tablet is disconnected from external
power to determine the battery pack charge level before you begin charging the
battery pack. Table 1-1 on page 1-5 shows the battery pack charge level represented
by the Low-Battery LED. The lower the battery level, the longer the battery pack
will require for recharging.
2. Connect the pen tablet to an external power source. The Charge LED flashes once
when external power is initially connected. The Charge LED will then indicate
whether the charge level is above or below 90% as discussed in Table 1-1 on page
1-5. (Note that external power can be provided by a source such as an AC adapter
or a connectivity peripheral that provides DC power.)
If the battery pack charge is below 90%, the battery pack charges in fast charge
mode. If the battery pack charge is 90% or higher, the battery pack charges in slow
charge mode. (This protects the battery pack from being overcharged.)
If fully discharged, the battery pack recharges to 90% in about 90 minutes. (Charging
may take longer if peripherals are attached.) You can use the pen tablet, suspend
system operation, or shut down the system, without interrupting the charging process.
Also, note that there is no "memory effect". You can begin charging the battery pack at
any charge level.
Charging the Battery Pack (While Installed in the Pen Tablet)
2
2-11