- ページ 25

マザーボード Fujitsu SK-96390-100PMCのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu SK-96390-100PMC 32 ページ。 Mb96300 series

Fujitsu SK-96390-100PMC ユーザーマニュアル

4 Programming the internal Flash memory

All Flash devices have an internal bootloader for asynchronous- as well as for synchronous-
Flash-programming:
< Asynchronous serial Flash programming via X3 or X5 (UART0 or UART1)
< Synchronous serial Flash programming via X17 (UART2)

4.1 Asynchronous Mode

This chapter describes the serial asynchronous programming of the internal Flash memory
using 'Flash Memory Programmer 16FX' in automatic mode.
For serial asynchronous programming SUB-D9 connectors X3 or X5, which are connected to
UART0 and UART1 respectively, can be used on the starter kit.
The following jumper settings are necessary:
4.1.1 UART0
Programming
Jumper
JP2
UART0
(SIN0)
JP1
UART0
(SOT0)
Table 4-1: Jumper Settings for Programming via UART0 (X3)
4.1.2 UART1
Programming
Jumper
JP6
UART1
(SIN1)
JP8
UART1
(SOT1)
Table 4-2: Jumper Settings for Programming via UART1 (X5)
© Fujitsu Microelectronics Europe GmbH
SK-96390-100PMC User Guide
Chapter 4 Programming the internal Flash memory
Setting Description
UART
1-2
1-2
Setting Description
UART
1-2
1-2
SIN0 is connected to RxD of X3
SOT0 is connected to TxD of X3
SIN1 is connected to RxD of X5
SOT1 is connected to TxD of X5
- 25 -
UG-960017-11