- ページ 14

調理器 Indesit KD341GWのPDF 取付・使用説明書をオンラインで閲覧またはダウンロードできます。Indesit KD341GW 24 ページ。 50cm gas cooker

Care and Cleaning

Clean the cooker regularly and wipe up spills soon after they occur to prevent

them from becoming burnt on.

TURN OFF THE MAIN SWITCH AND ENSURE THE COOKER IS COLD BEFORE CLEANING.

BEFORE SWITCHING ON AGAIN, ENSURE THAT ALL CONTROLS ARE IN THE OFF POSITION.

NEVER USE BIOLOGICAL WASHING POWDER, CAUSTIC CLEANERS, HARSH ABRASIVES,

SCOURING PADS, STEAM CLEANERS, AEROSOL CLEANERS OR OVEN CHEMICAL CLEANERS

To move the cooker forward, open the grill door and with both hands positioned

under the roof of the compartment, lift and pull forward.

Replace by pushing the cooker backwards. Check that the cooker is level.

Take care to ensure that any floor covering is not damaged.

Do not attempt to lift the product using the grill door or grill door handle.

OVEN SHELF SUPPORTS

The shelf supports are removable and dishwasher safe.

To remove hold the support at the front and pull away from the oven side, this can

then be cleaned in a sink or a dishwasher.

When removed it allows access to the oven side, which can be cleaned with warm

soapy water.

To refit the support, insert the longer leg into the rear fixing hole and push in the front

leg.

OVEN DOOR / GRILL DOOR

Wipe over the door outer panel with a cloth wrung out in hot soapy water, then after

wiping with a cloth wrung out in clear water, dry with a soft clean cloth.

Take care during cleaning not to damage or distort the Door Seal. Do not lift the Door

Seal from the Oven Front Frame, if necessary remove the seal by carefully unhooking

the corner clips.

Do not use scouring pads or abrasive powder which may scratch the surface.

REPLACING THE BATTERY

The battery is not covered by the guarantee. Use an alkaline AA battery. The battery

holder is located in the plinth panel below the oven door. Open the oven door fully.

Press the tag on the left hand side of the battery holder/cover and withdraw it just

enough to get access to the battery.

Fit the new battery with the end marked "+" on the same side of the battery holder as

the red lead. Replace the battery holder by pushing it firmly into the hole in the plinth.

OF ANY KIND.