- ページ 21

冷凍庫 AEG ARCTIS 0833-6iのPDF 操作および設置マニュアルをオンラインで閲覧またはダウンロードできます。AEG ARCTIS 0833-6i 23 ページ。 Integrating freezer

Malfunction
The freezer temperature is
not sufficient, red light lights
up, temperature signal
sounds
Heavy build up of frost, pos-
sibly also on the door seal.
Unusual noises.
The compressor does not
start immediately after chan-
ging the temperature set-
ting.
Important: regularly check on the red temperature pilot lamp and
thermometer that the storage temperature is being maintained
42
Possible Cause
Temperature is not properly
adjusted.
Door was open for an exten-
ded period.
A large quantity of warm
food was placed in the
appliance within the last 24
hours.
The appliance is near a heat
source.
Disturbance on the applian-
ce
Door seal is not air tight
(possibly after changing
over the hinges).
Appliance is not level.
The appliance is touching
the wall or other objects.
A component, e.g. a pipe,
on the rear of the appliance
is touching another part of
the appliance or the wall.
This is normal, no error has
occurred.
Remedy
Please look in the "Initial
Start Up" section.
Open the door only as long
as necessary.. Press the
fast freeze switch
Press the fast freeze switch
Please look in the "Installa-
tion location" section.
Switch on the fast freeze
switch, keep the freezer clo-
sed, inform your customer
service
Carefully warm the leaking
sections of the door seal
with a hair dryer (not hotter
than approx. 50 ¡C). At the
same time shape the war-
med door seal by hand such
that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend
the component out of the
way.
The compressor starts after
a period of time.