AEG ARCTIS 0833-6i 운영 및 설치 매뉴얼 - 페이지 21

{카테고리_이름} AEG ARCTIS 0833-6i에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG ARCTIS 0833-6i 23 페이지. Integrating freezer

페이지 인쇄

1. Operating and Indicator Panel

Malfunction

The freezer temperature is

not sufficient, red light lights

up, temperature signal

sounds

Heavy build up of frost, pos-

sibly also on the door seal.

Unusual noises.

The compressor does not

start immediately after chan-

ging the temperature set-

ting.

Important: regularly check on the red temperature pilot lamp and

thermometer that the storage temperature is being maintained

Possible Cause

Temperature is not properly

adjusted.

Door was open for an exten-

ded period.

A large quantity of warm

food was placed in the

appliance within the last 24

hours.

The appliance is near a heat

source.

Disturbance on the applian-

Door seal is not air tight

(possibly after changing

over the hinges).

Appliance is not level.

The appliance is touching

the wall or other objects.

A component, e.g. a pipe,

on the rear of the appliance

is touching another part of

the appliance or the wall.

This is normal, no error has

occurred.

Remedy

Please look in the "Initial

Start Up" section.

Open the door only as long

as necessary.. Press the

fast freeze switch

Press the fast freeze switch

Please look in the "Installa-

tion location" section.

Switch on the fast freeze

switch, keep the freezer clo-

sed, inform your customer

service

Carefully warm the leaking

sections of the door seal

with a hair dryer (not hotter

than approx. 50 ¡C). At the

same time shape the war-

med door seal by hand such

that it sits correctly.

Readjust the feet.

Move the appliance slightly.

If necessary, carefully bend

the component out of the

way.

The compressor starts after

a period of time.