- ページ 18

換気フード AEG CHDF 6260のPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。AEG CHDF 6260 21 ページ。 Electrolux cooktop user manual
AEG CHDF 6260 にも：操作およびインストール手順 (21 ページ), 操作および設置マニュアル (21 ページ), 操作および設置マニュアル (22 ページ), 操作およびインストール手順 (23 ページ), 操作およびインストール手順 (22 ページ)

• If the cupboard is deeper than 300 mm, cover the gap between the

hood and the wall with a finishing strip (special accessory).

To install it, proceed as follows:

Measure the wall distance and apply the covenng strip over the

necessary width (wall distance plus 5 to 8 mm), kinking the covering

strip at the appropriate notches and tearing off the surplus material

(removing the protective foil).

Then fasten the strip to the bottom part of the hood with three clips

(special accessories). Apply pressure. Fig. 8.

Fig. 8

Fitting the carbon filter for filter version

If the fume extractor hood is installed as a return air appliance (Filter

version - air outlet above the wall unit), the carbon filter (special

accessory) must be fitted before the grease filters are fitted.

Installation sequence:

1. Insert the holding frame for the carbon filter in the shaft of the hood

with the 2 lugs facing upwards and then clip into the lower holes.

2. Fix the holding frame on the lower part of the housing of the hood

with the 2 screws supplied. Fig. 9.

3. Fit the carbon filter (see paragraph "Carbon filter")

4. Refit the grease filters. Push-in the vapour catcher.

Fig. 9