AEG CHDF 6260 작동 및 설치 지침 - 페이지 18

{카테고리_이름} AEG CHDF 6260에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG CHDF 6260 21 페이지. Electrolux cooktop user manual
AEG CHDF 6260에 대해서도 마찬가지입니다: 작동 및 설치 지침 (21 페이지), 운영 및 설치 매뉴얼 (21 페이지), 운영 및 설치 매뉴얼 (22 페이지), 작동 및 설치 지침 (23 페이지), 작동 및 설치 지침 (22 페이지)

• If the cupboard is deeper than 300 mm, cover the gap between the

hood and the wall with a finishing strip (special accessory).

To install it, proceed as follows:

Measure the wall distance and apply the covenng strip over the

necessary width (wall distance plus 5 to 8 mm), kinking the covering

strip at the appropriate notches and tearing off the surplus material

(removing the protective foil).

Then fasten the strip to the bottom part of the hood with three clips

(special accessories). Apply pressure. Fig. 8.

Fig. 8

Fitting the carbon filter for filter version

If the fume extractor hood is installed as a return air appliance (Filter

version - air outlet above the wall unit), the carbon filter (special

accessory) must be fitted before the grease filters are fitted.

Installation sequence:

1. Insert the holding frame for the carbon filter in the shaft of the hood

with the 2 lugs facing upwards and then clip into the lower holes.

2. Fix the holding frame on the lower part of the housing of the hood

with the 2 screws supplied. Fig. 9.

3. Fit the carbon filter (see paragraph "Carbon filter")

4. Refit the grease filters. Push-in the vapour catcher.

Fig. 9