- ページ 20

換気フード AEG protect d. 2000のPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。AEG protect d. 2000 25 ページ。 Fume extractor hood

Proceed as follows to remove and change my activated

carbon filter:

Switch of the fan motor by pressing the

Take the precaution of removing my cartridge fuses from

their fuse holders or tripping my automatic circuit

breaker to ensure the fan motor cannot be switched on

accidentally.

The activated carbon filter cannot be cleaned or reused.

Remove the metal filters.

Unscrew the two screws on the activated carbon filter

frame and remove the old filter. Fig. 2

Clean the inner housing using a hot detergent solution

only (never use caustic detergents, abrasive powders or

brushes).

Mounting the carbon filter:

Insert a new activated carbon filter into the carbon filter

Fig. 2

frame. Fig. 2

Fig. 2

Fig. 2.

Close the activated carbon filter frame again using the

two screws provided.

Refit the metal filters.

Screw the fuses back in or reset the automatic circuit

breaker.

Proceed as follows to reset the filter saturation display

(counter): Select any fan speed using

and then press the

time, continuing to hold them down for at least 3 seconds

until the flashing letter C stops being shown on the

display (D) and then press the

The activated carbon filter display is now ready for use

again.

Fig. 2.

Fig. 2

B and

F buttons at the same

button B.

button.

E or

F buttons