- ページ 10

バスルーム設備 Kohler ARICA K-705230のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Kohler ARICA K-705230 12 ページ。 Neo-angle shower enclosures

Q. INSTALL DRIP RAIL AND INSERT

The drip rail base should be on the bottom of the glass

panel with the flat side towards the inside (wet side) of the

shower. If the drip rail is currently located at the top of the

glass panel, slide off both pieces and push onto the

bottom of the glass panel.

Slide the drip rail insert into the longer drip rail base,

through the length of base and into the smaller drip rail

base. Position insert cut-out around the edge of the

decorative pivot cover installed on the door panel.

Align each end of the drip rail insert with the ends of the

drip rail base and trim excess from each end. Trim the

short end of the insert back 1/2" (1.3cm) from the edge of

the glass to prevent interference with the door seal.

R. SEALING

Thoroughly clean all dust, dirt and grease from the bottom

frame and shower ledge surfaces to be sealed. Make sure

surfaces are dry.

CAUTION: Risk of product damage. Apply

silicone sealant around the outside of the enclosure

only . Sealant applied to the inside of the enclosure

will cause leakage and damage.

Carefully apply a bead of silicone sealant around the

outside (dry side) of door where:

1) Bottom frame meets the shower ledge.

2) Wall jambs meet the shower walls.

116896-2-

Drip Rail Base

Trim

Drip Rail

Insert

Kohler Co., Kohler, WI U.S.A.