- ページ 21

ドライヤー AEG LAVATHERM 56740のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG LAVATHERM 56740 32 ページ。 Aeg condenser dryer user manual

ページを印刷する

Displayed programme time

changes erratically or stays un-

changed for a long time.

Programme inactive, empty

water tank warning led is light-

ing.

Drying cycle ends shortly after

programme starts.

Drying cycle lasts an unusually

long time. Note: After around 5

hours the drying cycle ends au-

tomatically (see „Drying cycle

complete ").

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The special bulb can be

obtained from your local service centre.

When the appliance is switched on, the interior lighting switches itself off after 4 minutes

when the door is open.

WARNING!

Do not use standard bulbs! These develop too much heat and may damage the machine!

Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully

unscrew or deactivate the fuse.

1. Unscrew cover above the bulb (this can be found directly behind the loading aperture,

at the top; refer to "Description of machine" section.)

2. Replace defective bulb.

3. Screw cover back down.

Check the correct positioning of o-ring gasket before screwing back the door light cover.

Do not operate the dryer when missing o-ring gasket on door light cover.

WARNING!

For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer

must not be operated.

Programme time is corrected

automatically depending on

type and volume of laundry

and level of dampness.

Condensate tank is full.

Not enough washing loaded or

washing loaded is too dry for

selected programme.

Lint filter clogged.

Fluff filter clogged.

Load volume too big.

Laundry insufficiently spun.

Particularly high room temper-

ature. Temporary switching off

of the compressor to avoid

overload.

What to do if ...

Automatic process; this is not a

machine fault.

Empty condensate tank, then

start programme with START

PAUSE button.

Select time programme or

higher drying level (e.g. EXTRA

DRY instead of STORAGE DRY).

Clean lint filter.

Clean fluff filter.

Reduce load volume.

Laundry must be adequately

spun.

Automatic process, there is no

fault with the appliance. If pos-

sible, lower the room tempera-

ture.