AEG LAVATHERM 56740 Manual do utilizador - Página 21
Procurar online ou descarregar pdf Manual do utilizador para Secador AEG LAVATHERM 56740. AEG LAVATHERM 56740 32 páginas. Aeg condenser dryer user manual
Imprimir página
Displayed programme time
changes erratically or stays un-
changed for a long time.
Programme inactive, empty
water tank warning led is light-
ing.
Drying cycle ends shortly after
programme starts.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically (see „Drying cycle
complete ").
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can be
obtained from your local service centre.
When the appliance is switched on, the interior lighting switches itself off after 4 minutes
when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the machine!
Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully
unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this can be found directly behind the loading aperture,
at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket before screwing back the door light cover.
Do not operate the dryer when missing o-ring gasket on door light cover.
WARNING!
For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer
must not be operated.
Programme time is corrected
automatically depending on
type and volume of laundry
and level of dampness.
Condensate tank is full.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room temper-
ature. Temporary switching off
of the compressor to avoid
overload.
What to do if ...
Automatic process; this is not a
machine fault.
Empty condensate tank, then
start programme with START
PAUSE button.
Select time programme or
higher drying level (e.g. EXTRA
DRY instead of STORAGE DRY).
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately
spun.
Automatic process, there is no
fault with the appliance. If pos-
sible, lower the room tempera-
ture.
21