- ページ 5

バスタブ Kohler K-11344のPDF インストレーション＆ケア・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler K-11344 45 ページ。 Freestanding bath
Kohler K-11344 にも：インストレーション＆ケア・マニュアル (28 ページ), インストレーション・マニュアル (25 ページ), ラフイン・マニュアル (4 ページ)

Bond in accordance

with applicable codes.

1. Prepare the Site

NOTICE: Measure your product for site preparation. Note the model number located on the

pump/blower end of the bath, then visit the product page at www.kohler.com for more information.

Install an access panel to service the blower motor.

Prepare the routing paths for the PVC piping and keypad cable. Follow all applicable building, ﬁre,

plumbing, and electrical codes.

Carefully unpack and inspect the new bath for damage before installation. If there is damage do not

install the bath; contact your dealer.

Make sure the ﬂooring offers adequate support for the bath, and verify that the subﬂoor is ﬂat and

level.

Install the rough plumbing.

Determine the location of the bath. Provide a minimum clearance of 24" (610 mm) around the

perimeter of the bath.

IMPORTANT! To ensure a successful installation, it is critical that the bath be installed on a perfectly

level ﬁnished ﬂoor.

Apply the ﬁnished ﬂooring material prior to installing the bath.

Conﬁrm the ﬁnished ﬂoor is perfectly level before proceeding with the bath installation.

Kohler Co.

24" (610 mm) Max. Distance

Between Blower and Outlet

Air Intake

Install a GFCI-protected

120 V, 15 A grounded outlet.

1220597-2-A