- ページ 5

エンジン Kohler SNOWPRO WH208のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Kohler SNOWPRO WH208 12 ページ。 Horizontal crankshaft
Kohler SNOWPRO WH208 にも：オーナーズマニュアル (17 ページ)

ページを印刷する

1. Change Oil

2. Remove the Torx screws securing the engine

cover. See Figure 9.

Torx Screws

Figure 9. Remove Torx Screws.

3. Do not fully remove the cover from the engine.

The primer hose and the key switch wires are still

attached at this time.

Disconnect Primer Assembly Hose

1. Pull the hose off the back of the primer assembly.

See Figure 10.

Stop/Run

Key Switch

Wires

Figure 10. Remove Hose and Wires.

Disconnect Key Switch Wires

1. Remove the stop/run key switch wires from the

back of the engine cover. See Figure 10.

2. The engine cover can now be set aside.

Remove Air Box

1. Remove one hex flange screw and two hex

nuts securing the air box to the carburetor, and

remove the air box from the studs. See Figures 11

and 12.

Figure 11. Remove Air Box Screw.

Figure 12. Remove Air Box Hex Nuts.

Remove Electric Starter (If Equipped)

Primer Hose

1. Remove the hex flange screws securing the

Figure 13. Remove Electric Starter.

Hex Nuts

electric starter to the crankcase, and remove the

electric starter. See Figure 13.

Hex Flange

Screws

Hex Flange

Screws