- ページ 4

室内装飾品 Kohler TOOBI II SeriesのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Kohler TOOBI II Series 6 ページ。 Vanity tops & cabinets

INSTALLATION

Water supply and waste pipe holes

(a) Measure and mark the centres for water

supply & waste pipes on the back of the

cabinet. With a suitably sized hole saw drill

the holes for the water supply and waste.

(b) Having drilled the required holes, fit the

cabinet into position over the pipework.

Fixing the vanity to the wall

(a) Before fastening the cabinet make sure that

it is sitting level and square.

(b) Fix the cabinets to the wall using screws (min

10g x 75mm) and *20mm washers.

pattern as shown in Fig. 2.

• 600mm cabinets require a minimum of 5 screws

• 900mm cabients require a minimum of 7 screws

Vanity Top Installation

(a) Unpack the top and check for any damage that

might have occured in transit. Check and

confirm the fit of your selected tapware.

Please disregard the supplied fixing kit.

(b) Apply a continuous bead of silicone (not

supplied) to the top edge of the cabinet sides

and back. Ensure there are no gaps in the

sealant bead. This will ensure the top stays

securely fitted to the cabinet and no water

spillage will find its way into the cabinet.

that the back is flush against the wall and

there is an even overhang on either side of the

cabinet.

(d) Wipe off any excess sealant.

-4-

Fig. 2