- ページ 15

コントローラー Aqua Computer farbwerkのPDF ユーザー・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Computer farbwerk 20 ページ。 High power led controller for pcs

aqua

computer

10.2. Color settings

Depending on the current controller mode, one or two colors can be defined. Col-

ors can conveniently be set using the graphical color and brightness selectors, al-

ternatively corresponding values can be set manually. The "Optimized colors for

Aqua Computer LED strip" function enables color optimization for the LED strips

available from Aqua Computer.

In temperature controlled mode, two colors can be defined corresponding to two

temperature readings. The farbwerk controller generates a color gradient for tem-

perature sensor values between these limits. The "Controller source low pass filter"

setting influences sensor reading smoothing for a steady color gradient.

The "Refresh speed" setting determines how often the controller is updated.

For some controller modes, a fading effect can be activated. By defining the eight

points of the effect curve, a pulsating brightness of the corresponding LED output

can be set.

11. System settings farbwerk (aquasuite)

Select "System" from the device list for the device to be configured.

11.1. Device information

The details displayed here might be required when you contact our service for sup-

port.

11.2. Factory defaults

Click the button "Reset device to factory defaults" for a complete reset of all set-

tings. You will have to completely reconfigure the device after resetting it to factory

defaults!

11.3. aquabus configuration

11.3.

aquabus configuration

Before connecting farbwerk devices to an aquaero 5/6 controller, each farbwerk

device has to be configured to an individual aquabus address. You may skip this

step if only one farbwerk device is connected. Addresses 20 and 21 are available

for farbwerk devices.

Aqua Computer GmbH & Co. KG

Gelliehäuser Str. 1, 37130 Gleichen

FARBWERK

- 15 -