- ページ 7

水ポンプ Aqua Computer AQUASTREAM XT USBのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aqua Computer AQUASTREAM XT USB 16 ページ。
Aqua Computer AQUASTREAM XT USB にも：ユーザー・インストール・マニュアル (20 ページ)

ページを印刷する

aqua

computer

Version 11/2007

MANUAL AQUASTREAM XT

XT has an excess temperature protection unit so that a switching off is

automatically carried out at a too high load to avoid damages. The output,

however, is not short-circuit proof!

6.5. Attach an external temperature sensor (only ultra-variant)

Attach a 10 kΩ NTC temperature sensor (Order no. 53026) at the

connection "deaeration/ext. temp" while the PC is turned off. Place the sensor

top to the point whose temperature you would like to measure.

Caution: Place the sensor under no circumstances between processor and

cooler! Moreover, do not expose the sensor to any pressure since it is very

sensitive.

6.6. Attaching flow rate sensor (only ultra-variant) or aquabus (all variants)

At the standard and advanced variant the connection "aquabus/flow" is

configured as an aquabus and can be used e.g. To connect the pump to an

optionally available aquaero. A use as a connection for a flow sensor is not

possible at these variants!

This connection is covered with two functions at the ultra variant. In the

delivery state the connection is configured as an aquabus, however, the

aquasuite software can be used to configure the connection to be used with a

flow sensor. A simultaneous use of aquabus and flow sensor is not possible at

the connection. You find details for the available settings in the aquasuite

software on page 11.

The flow sensor and the special interconnecting cable are optional

accessories and can be purchased separately.

6.7. Internal water temperature sensor (only ultra-variant)

The aquastream XT has an internal water temperature sensor which is already

pre-assembled. This sensor can be monitored only in the aquastream XT

ultra-variant.

6.8. Internal temperature sensor for the controller board

The controller board of the aquastream XT is equipped with a pre-assembled

temperature sensor. The advanced- and ultra variant has in addition a two-

step protective function to avoid an overload of at the fan connector and a

possible damage to the controller board.

Aqua Computer GmbH und Co. KG

Page 7

Gelliehäuser Str. 1 – D-37130 Gleichen - Germany