- ページ 3

リフティングシステム Aqua Creek F-043SCHのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aqua Creek F-043SCH 14 ページ。 24v patriot patient pool lift solar charger

ページを印刷する

BATTERY CABLE

CONNECT TUBE

LOWER MAST

BATTERY CABLE

CHARGE CONNECTOR

To assemble the Solar Charger you will need two (2) 7/16" wrenches or sockets.

The 24V Solar-Charger comes fully wired, in two halves for shipping. To assemble the charger remove it

from the shipping box and connect the UPPER MAST to the LOWER MAST by fl ipping the UPPER MAST up

and sliding the CONNECT TUBE inside the UPPER MAST and aligning the holes as shown above. Pull the

BATTERY CABLE and the CHARGE CONNECTOR through the tube as you slide the TOP ASSEMBLY down.

DO NOT PINCH THE BATTERY CABLE! Install the supplied 1/4" x 1 1/2" hex bolt, the fl at washers and

Nylock-nut as shown. Tighten until snug.

Next, fl ip-up the SOLAR PANEL ASSEMBLY until it is fl at-horizontal, and install the 1/4" x 1 3/4" hex bolt

and fl at washer underneath as shown. Install the 2nd fl at washer and the Nylock nut on the opposite

side, and tighten until snug. The Solar Charger is now ready to install on your pool lift.

Unpacking And Assembly

1/4" NYLOCK

NUT

1/4" FLAT

WASHER (2)

1/4" X 1-3/4"

HEX BOLT

UPPER MAST

1/4" NYLOCK

NUT

1/4" FLAT

WASHER (2)

1/4"-20 X 1 1/2"

BUTTON HEAD

W/ SLEEVE SHRINK

SOLAR-PANEL

ASSEMBLY

BATTERY CABLE

CHARGE CONNECTOR

SOLAR PANEL

ASSEMBLY

FLIP-UP

SOLAR CHARGE

CONTROLLER

FLIP UP

BATTERY CABLE

DO NOT PINCH!

CONNECT

TUBE

LOWER MAST

MOUNTING POST

(

1/2"-13 THREAD)

Revised 12/13/16