Aqua Creek F-043SCH 사용 설명서 - 페이지 3

{카테고리_이름} Aqua Creek F-043SCH에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek F-043SCH 14 페이지. 24v patriot patient pool lift solar charger

BATTERY CABLE
CONNECT TUBE
LOWER MAST
BATTERY CABLE
CHARGE CONNECTOR
To assemble the Solar Charger you will need two (2) 7/16" wrenches or sockets.
The 24V Solar-Charger comes fully wired, in two halves for shipping. To assemble the charger remove it
from the shipping box and connect the UPPER MAST to the LOWER MAST by fl ipping the UPPER MAST up
and sliding the CONNECT TUBE inside the UPPER MAST and aligning the holes as shown above. Pull the
BATTERY CABLE and the CHARGE CONNECTOR through the tube as you slide the TOP ASSEMBLY down.
DO NOT PINCH THE BATTERY CABLE! Install the supplied 1/4" x 1 1/2" hex bolt, the fl at washers and
Nylock-nut as shown. Tighten until snug.
Next, fl ip-up the SOLAR PANEL ASSEMBLY until it is fl at-horizontal, and install the 1/4" x 1 3/4" hex bolt
and fl at washer underneath as shown. Install the 2nd fl at washer and the Nylock nut on the opposite
side, and tighten until snug. The Solar Charger is now ready to install on your pool lift.
Copyright © 2016 Aqua Creek Products All Rights Reserved

Unpacking And Assembly

1/4" NYLOCK
NUT
1/4" FLAT
WASHER (2)
1/4" X 1-3/4"
HEX BOLT
UPPER MAST
UPPER MAST
1/4" NYLOCK
NUT
1/4" FLAT
WASHER (2)
1/4"-20 X 1 1/2"
BUTTON HEAD
W/ SLEEVE SHRINK
SOLAR-PANEL
ASSEMBLY
BATTERY CABLE
CHARGE CONNECTOR
SOLAR PANEL
ASSEMBLY
FLIP-UP
SOLAR CHARGE
CONTROLLER
FLIP UP
BATTERY CABLE
DO NOT PINCH!
CONNECT
TUBE
LOWER MAST
MOUNTING POST
(
1/2"-13 THREAD)
Revised 12/13/16
3