- ページ 6

洗濯機 Dexter Laundry T-1450のPDF プログラミング説明書をオンラインで閲覧またはダウンロードできます。Dexter Laundry T-1450 7 ページ。 Opl programming v-series

RAPID ADVANCE MODE

To enter the Rapid Advance mode, turn the key CCW. The Rapid Advance setting is not marked

next to the key, but turning the CCW until it stops selects this mode. The Rapid Advance mode

can be entered from either the Idle mode or during the cycle. If the cycle has not yet started,

press the "START" button. To rapid advance to the next step in the wash cycle, push both the

"UP" and "START" buttons at the same time. The display will show an "Ad" (advance) in the

display. The washer will advance to the next bath segment. The water will drain before the

advance will occur and the time displayed may not be accurate.

Notes: - The indicator lights will show to which segment the cycle has been advanced.

- The cycle will continue in rapid advance mode even if the key is turned to "RUN" and/or

removed.

- Rapid advance cannot skip the final 1-minute tumble of the cycle, and the door lock may

remain activated for a couple minutes after the cycle has been completed.

-Chemical 120volt signals will be lost after Rapid advance Mode has been activated until

cycle resets.

To exit the Rapid Advance mode, push and hold the STOP button.

INJECTION SOURCE DETAILS

The washer control may be programmed to send output signals for a chemical injection system.

There is a separate terminal block for connection of the external injection signals. For the

injection sources, program codes 0 through 6 are as shown in the table below.

Recommended

Connections

Detergent

Sour/Softener

Dexter

Controller

Programmed

Signals

Bleach

Starch

Injection

Terminal Block

Circuits

A and B

C and D

None