Dexter Laundry T-1450 Instrukcja programowania - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja programowania dla Spryskiwacz Dexter Laundry T-1450. Dexter Laundry T-1450 7 stron. Opl programming v-series
Drukuj stronę
RAPID ADVANCE MODE
To enter the Rapid Advance mode, turn the key CCW. The Rapid Advance setting is not marked
next to the key, but turning the CCW until it stops selects this mode. The Rapid Advance mode
can be entered from either the Idle mode or during the cycle. If the cycle has not yet started,
press the "START" button. To rapid advance to the next step in the wash cycle, push both the
"UP" and "START" buttons at the same time. The display will show an "Ad" (advance) in the
display. The washer will advance to the next bath segment. The water will drain before the
advance will occur and the time displayed may not be accurate.
Notes: - The indicator lights will show to which segment the cycle has been advanced.
- The cycle will continue in rapid advance mode even if the key is turned to "RUN" and/or
removed.
- Rapid advance cannot skip the final 1-minute tumble of the cycle, and the door lock may
remain activated for a couple minutes after the cycle has been completed.
-Chemical 120volt signals will be lost after Rapid advance Mode has been activated until
cycle resets.
To exit the Rapid Advance mode, push and hold the STOP button.
INJECTION SOURCE DETAILS
The washer control may be programmed to send output signals for a chemical injection system.
There is a separate terminal block for connection of the external injection signals. For the
injection sources, program codes 0 through 6 are as shown in the table below.
Recommended
Connections
Detergent
Sour/Softener
Dexter
Controller
Programmed
Signals
Bleach
Starch
Injection
Terminal Block
Circuits
1
A
2
B
3
C
4
D
5
A and B
6
C and D
0
None