- ページ 8

リフティングシステム Aqua Creek Products F-411RPL-AT1-02のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Creek Products F-411RPL-AT1-02 16 ページ。 Ranger-at pool lift

ページを印刷する

1. Attach seat belt to the seat.

2. Install the Ranger-AT pool lift onto the four (4) anchors

using the supplied 1/2 inch x 1 1/2 inches stainless steel hex-

head bolts and 1/2 inch stainless steel washers. Make sure all

bolts are tight before using the lift.

3. Apply dielectric grease to the plug terminals, including

the o-ring seal. Plug the handset cable into the large handset

socket on the bottom of the control box. Press the cord end

fi rmly into the socket until you are sure it is completely in the

socket. Failure to fully push the remote cord into the socket may result in faulty or interrupted

operation.

4. Before installing the battery, place it on the charging unit and let it charge for 24 hours. Make

sure the orange "charge" light illuminates when the battery is being charged.

5. Remove the fully charged battery from the charger and install it on top of the control box.

The battery will line up with the control box, and will 'click' when it properly locks in place. Apply

dielectric grease to the plug terminals,

including the o-ring seal, and then

connect the battery cable to the

control box cable.

6. With the lift fully assembled, run

the lift fully out and back in 3-5 times,

without weight, for the lifts "break in"

cycle period.

WHEN NOT IN USE, STORE THE

BATTERY ON THE CHARGER!

Ranger-AT Assembly Instructions

SEE FIGURE D

ATTACH

FULLY-CHARGED

BATTERY

CONTROL

BOX

1/2" X 1-1/2"

HEX BOLT (4)

1/2" FLAT

WASHER (3)

ANCHORS (4)

INSTALLED

FLUSH W/DECK

LOOP ON TOP

FOR EASY ACCESS

THREAD THROUGH

SLOTS AND PINCH

FIGURE D

TOGETHER TO HOLD

HANDSET

PLUGS INTO

CONTROL BOX

TOOTH

WASHER (1)

Revised 6/1/18

1/2" EXTERNAL

POOL

WALL