Aqua Creek Products F-411RPL-AT1-02 Manual - Página 8
Procurar online ou descarregar pdf Manual para Sistemas de elevação Aqua Creek Products F-411RPL-AT1-02. Aqua Creek Products F-411RPL-AT1-02 16 páginas. Ranger-at pool lift
Imprimir página1. Attach seat belt to the seat.
2. Install the Ranger-AT pool lift onto the four (4) anchors
using the supplied 1/2 inch x 1 1/2 inches stainless steel hex-
head bolts and 1/2 inch stainless steel washers. Make sure all
bolts are tight before using the lift.
3. Apply dielectric grease to the plug terminals, including
the o-ring seal. Plug the handset cable into the large handset
socket on the bottom of the control box. Press the cord end
fi rmly into the socket until you are sure it is completely in the
socket. Failure to fully push the remote cord into the socket may result in faulty or interrupted
operation.
4. Before installing the battery, place it on the charging unit and let it charge for 24 hours. Make
sure the orange "charge" light illuminates when the battery is being charged.
5. Remove the fully charged battery from the charger and install it on top of the control box.
The battery will line up with the control box, and will 'click' when it properly locks in place. Apply
dielectric grease to the plug terminals,
including the o-ring seal, and then
connect the battery cable to the
control box cable.
6. With the lift fully assembled, run
the lift fully out and back in 3-5 times,
without weight, for the lifts "break in"
cycle period.
WHEN NOT IN USE, STORE THE
BATTERY ON THE CHARGER!
8
Copyright © 2018 Aqua Creek Products All Rights Reserved
Ranger-AT Assembly Instructions
SEE FIGURE D
ATTACH
FULLY-CHARGED
BATTERY
CONTROL
BOX
1/2" X 1-1/2"
HEX BOLT (4)
1/2" FLAT
WASHER (3)
ANCHORS (4)
INSTALLED
FLUSH W/DECK
LOOP ON TOP
FOR EASY ACCESS
THREAD THROUGH
SLOTS AND PINCH
FIGURE D
TOGETHER TO HOLD
HANDSET
PLUGS INTO
CONTROL BOX
TOOTH
WASHER (1)
Revised 6/1/18
1/2" EXTERNAL
POOL
WALL