- ページ 3

コンピュータ・ハードウェア Avnet MSC Technologies ETE-A945GSEのPDF 取付方法をオンラインで閲覧またはダウンロードできます。Avnet MSC Technologies ETE-A945GSE 3 ページ。 Heat spreader ete/etx module

ページを印刷する

MSC ETE-A945

Heat Spreader Mounting Instructions

Rev. 1.1

Step 1: Insert the memory module into the memory socket. Make sure it is inserted correctly!

Step 2: Place the printed circuit board onto the heat spreader and fix it by tightening the two screws

marked below.

Step 3: Mount the ETE-A945GSE module on the baseboard and fix it securely with four screws as shown

below. (M2.5, lengths depends on customer's mechanical solution, 8-25mm)

NOTE:

The grey heat conducting pads are intended for one-time mounting only. If you need to remove the heat

spreader for service purposes and then reuse it, the wax-like material must be spread over the full die

surface again before re-mounting the heat spreader (see above, paragraph 2).

3 / 3