Avnet MSC Technologies ETE-A945GSE Instrukcja montażu - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Sprzęt komputerowy Avnet MSC Technologies ETE-A945GSE. Avnet MSC Technologies ETE-A945GSE 3 stron. Heat spreader ete/etx module
Drukuj stronęMSC ETE-A945
Heat Spreader Mounting Instructions
Rev. 1.1
Step 1: Insert the memory module into the memory socket. Make sure it is inserted correctly!
Step 2: Place the printed circuit board onto the heat spreader and fix it by tightening the two screws
marked below.
Step 3: Mount the ETE-A945GSE module on the baseboard and fix it securely with four screws as shown
below. (M2.5, lengths depends on customer's mechanical solution, 8-25mm)
NOTE:
The grey heat conducting pads are intended for one-time mounting only. If you need to remove the heat
spreader for service purposes and then reuse it, the wax-like material must be spread over the full die
surface again before re-mounting the heat spreader (see above, paragraph 2).
3 / 3