- ページ 2

リフティングシステム aqua greek products F-105LAR-01のPDF 使用方法をオンラインで閲覧またはダウンロードできます。aqua greek products F-105LAR-01 3 ページ。

The pull out legrest assembly is designed to t under the chair and is installed inside the 2" square

tubing that supports the chair from underneath. To install the pull out legrest;

1. With a at-blade screwdriver, pry o the 2" square plug from the end of the 2" square tube of

the seat arm.

2. Drill a 9/32" hole at the location indicated in the drawing below through the bottom of the

chair support tube. Drill only through the bottom of the tube. Remove the burrs from the hole

before installing the legrest assembly.

2" SQUARE

PLUG

Installation Instructions:

SEAT

DRILL

9/32" HOLE

(BOTTOM OF CHAIR SUPPORT TUBE)

(SEE FIGURE TO THE RIGHT)

SEAT ARM

DRILL

9/32"

3/4"

(THIS SIDE)

Revised 2/28/18