- ページ 3

チラー Aqua Logic DS seriesのPDF 取付・取扱説明書をオンラインで閲覧またはダウンロードできます。Aqua Logic DS series 4 ページ。 Water-cooled

Installation and Operating Instructions for DS and MT chiller

WARNING: DO NOT over tighten water fittings.

Mount chiller on a flat cement pad and away for water spray.

Give at least 2 feet all the way around unit for servicing.

Install process water inlet and outlet.

Install condenser water inlet and outlet.

Test water fittings for leaks.

Apply electrical power to the chiller.

In cold weather below 60°F, allow approximately 4 hours for compressor oil warm-up.

Adjust the controller to the desired water temperature. (See "Operation and Programming")

Warning: This unit must have proper water flow rate both on the process and the

condenser to operate correctly.

Note: Controller has been pre-programmed by the factory for chiller operation. The

temperature is the only setting that needs to be changed.

ANNUNCIATOR

STEP

F or C

S1 (blinking)

DIF1 (blinking)

C1/H1

Tel: (858) 292-4773 Fax: (858) 279- 0537

Start-up and installation:

Operation and programming:

DESCRIPTION

Fahrenheit or Celsius Scale

Stage 1 Setpoint Temperature

Stage 1 Differential

Temperature

Stage 1 Heating Mode

Aqua Logic®, Inc.

8268 Clairemont Mesa Blvd. Suite 302

DISPLAY

DIF1

San Diego, CA 92111