Aqua Logic DS series Installatie- en bedieningsinstructies - Pagina 3

Blader online of download pdf Installatie- en bedieningsinstructies voor {categorie_naam} Aqua Logic DS series. Aqua Logic DS series 4 pagina's. Water-cooled

Pagina afdrukken
Installation and Operating Instructions for DS and MT chiller
WARNING: DO NOT over tighten water fittings.
Mount chiller on a flat cement pad and away for water spray.
Give at least 2 feet all the way around unit for servicing.
Install process water inlet and outlet.
Install condenser water inlet and outlet.
Test water fittings for leaks.
Apply electrical power to the chiller.
In cold weather below 60°F, allow approximately 4 hours for compressor oil warm-up.
Adjust the controller to the desired water temperature. (See "Operation and Programming")
Warning: This unit must have proper water flow rate both on the process and the
condenser to operate correctly.
Note: Controller has been pre-programmed by the factory for chiller operation. The
temperature is the only setting that needs to be changed.
ANNUNCIATOR
STEP
1
F or C
2
S1 (blinking)
3
DIF1 (blinking)
4
C1/H1
Tel: (858) 292-4773 Fax: (858) 279- 0537
Start-up and installation:
Operation and programming:
DESCRIPTION
Fahrenheit or Celsius Scale
Stage 1 Setpoint Temperature
Stage 1 Differential
Temperature
Stage 1 Heating Mode
Aqua Logic®, Inc.
8268 Clairemont Mesa Blvd. Suite 302
DISPLAY
F
78
S1
DIF1
1
C1
San Diego, CA 92111
www.aqualogicinc.com