- ページ 4

送信機 DeZurik D10350のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。DeZurik D10350 9 ページ。 Switch and positioner transmitter

DeZURIK

Description

This valve accessory provides electrical functions in response to the open, closed, and intermediate

positions of a 2-way valve or a 2-position 3-way valve. Electrical switching and variable current

functions are provided in selected combinations. The adjustable sensing devices are mechanically

linked to a valve, a valve actuator, or a positioner.

Components are located in a sealed and accessible aluminum enclosure, constructed to comply with

NEMA types 4, 4X, 7 and 9. The position of the valve is visibly displayed in two windows at 180°

viewing angles. Three basic options consisting of mechanical switches, proximity switches, and a

position transmitter are provided individually or in selected combinations. The three options are

described below.

Field wiring enters through ¾" and ½" NPT electrical connections to a prewired and labeled terminal

strip as described in the following sections. One ½" pipe plug is provided with the unit. If the ½"

connection is not used, install the pipe plug tightly in the connection. Do not use thread sealant.

The two SPDT or four SPDT mechanical snap-acting switches each have a rating of:



Silver Contacts -10 Amps at 125/250 VAC, or 0.5 Amp at 125 VDC.



Gold Contacts - 1 Amp at 125 VAC, or 0.5 Amp at 30 VDC

With two SPDT switches, the top switch is factory set to trip as the valve reaches the closed or

clockwise position, and the bottom switch is factory set to trip as the valve reaches the open or counter-

clockwise position. The internal wiring from the switches to the terminal strip is shown in Figure 1.

With four SPDT switches, the top (first) switch is factory set to trip as the valve reaches the closed or

clockwise position, and the bottom (fourth) switch is factory set to trip as the valve reaches the open or

counterclockwise position. The second and third switches are not factory set, but may be set in the

field. The internal wiring from the switches to the terminal strip is shown in Figure 2.

D10350

Figure 1— Mechanical Switches

Page 4

May 2014