- ページ 9

アンプ DFE TRUETENSION TA1のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。DFE TRUETENSION TA1 12 ページ。 Tension amplifier
DFE TRUETENSION TA1 にも：取扱説明書 (16 ページ)

Normal Operation = Solid Green

1 BLINK = No Calibration Performed

Action Required:

Perform Calibration. TA1 is not factory calibrated. A calibration

must be performed at the customers site. Each calibration is specific to the

installation configuration. If using CAL B – a separate calibration must be performed.

2 BLINKS = Outside Cal Range

Once calibrated the TA1 will indicate an over range or under range condition by

setting the error code to 'Outside Cal Range' . The error is active once -20% or 120%

tension is exceeded.

Action Required:

To clear this error the tension must be brought back into rang, or

a new calibration will need to be performed to do so.

3 BLINKS = Wiring Error

Will alert until the load cell are wired correctly.

Action Required:

Check wiring and retry. Refer to page 4. Check for loose wires at

the terminal blocks, check for shorts, and be sure the load cells are connected. If the

transducers need trouble shooting – contact tech support for assistance.

Overload Condition (LT Transducer):

Will intermittenly alert if overload is reached.

Action Required:

Check that the tension range does not exceed the transducer

load rating. Reduce wrap angle to reduce effective net force exerted on load cell.

TROUBLESHOOTING