- ページ 3

医療機器 ALLIED MEDICAL Spectrum Healthcare ErgoRaiserのPDF 説明書とマニュアルをオンラインで閲覧またはダウンロードできます。ALLIED MEDICAL Spectrum Healthcare ErgoRaiser 4 ページ。

Multiple Configurations - support on a raised surface

Please note:

any raised surface must be designed to support the human load and assessed as providing a safe stable

platform for the required module(s).

Further information, instructions and guidelines

Registered: Safe Working Load in all configurations – 80kg (BS EN 12182:2012.)

The support pad

The ergonomic shaping of the pad in conjunction with the polyurethane foam of which it is made, comfortably cradles the

limb in all positions. The pad may be transferred to whichever surface is to form the support platform for the limb and is

anchored in position by fitting the raised plug on the underside securely into the appropriate socket on the module. Care

must be taken that the pad is securely in position and clean before allowing the limb to rest.

Stowing the top module and pad inside the lower module

To enable stowage, the top module and pad assembly must be correctly orientated and aligned

to match the shape of the cavity. To aid this process the small arch (a) on the side wall of the top

module, should be aligned with the raised guide rail (b) on an inside wall of the cavity. The top

module and pad will then slide into the lower module and can be secured in place by the lid.

When unloading, the small arch provides a finger hold to aid withdrawal of the assembly.

Operating the latch to remove and refit the lid



To open the latch: loosen both knobs on the latch just sufficiently to allow you to slide the

latch bar fully backwards out of its slot (d) on the module. Re-tighten knobs to hold latch

open. Remove lid.



To refit the lid: position the lid shape to match the shape of the cavity. Insert the protruding

tag on the lid edge furthest away from the latch into the corresponding slot (c) on the inner

wall of the module. Press the lid flat to rest against the internal ledge.



To close the latch: loosen the knobs just sufficiently to allow you to slide the latch bar fully

forwards into the adjacent slot (d) on the inner wall of the module. Once latch bar closed

into slot, fully tighten both knobs to ensure security of lid.



There are no hinges on the lid to trap dirt and bacteria; entire latch mechanism may be

dismantled for cleaning.

Dismantling and re-assembling the latch

WARNING – please note:

Before dismantling, note exact position of all component parts (see diag.). Ensure they are placed in same order when

re-assembling; failure to do this will render the latch ineffective.



Dismantling: Release and remove both knobs (1). Remove the latch bar (2). Release

and remove both hex nuts (3). Remove bolts (4).



Re-assembly: Push the bolts (4) through the holes from the underside of the lid. From

the outer side of the lid, thread and wind the hex nuts (3) onto the bolts and fully

tighten. Re-position the latch bar (2) over the bolts, chamfered end uppermost and

facing near outer edge of lid. Re-position top knobs (1) and tighten.

Latch contains small parts; to avoid risk of choking, keep away from small children.