- ページ 6

シンセサイザー AVP Synthesizers RITMOBOXのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AVP Synthesizers RITMOBOX 8 ページ。 Analog drum synthesizer with 8-step sequencer

Sequencer section

MIDI-channel selection setting

The 1

MIDI channel is set by default in RITMOBOX. To change it, turn off the

device then press and hold the START/STOP button, while continuing holding the

button turn on the device, continue holding it until the START/STOP starts

flashing.

The first MIDI note received from the MIDI controller will set the MIDI channel

number. After that, you need to Power off RITMOBOX and then turn it on again to

resume normal operation. Now the set MIDI channel will be stored in the device

memory.

START/STOP button

This button starts or stops the sequence playback. Sends START/STOP messages

to MIDI OUT.

Step selection button 8/16

The 8/16 LED indicator is not lit - only 1

8 steps are selected for programming.

The 8/16 LED indicator is lit - all 16 steps (1-16) are selected.

Step selection button 9-16

The 9-16 LED is not lit - first 8 steps are selected for programming.

The LED 9-16 is lit – 9-16 steps are available for programming.

8 buttons STEPS

Pressing one of the step buttons switches the state of this step to trigger note

on/off.

SOUND SELECTION button

This button selects one of the RITMOBOX's drum sections for editing on the

sequencer. Short pressing on the button allows to choose a specific sound for

programming on the steps.

TAP mode

You can enter into the TAP mode on the 5

press of SOUND SELECTION button

(all 5 led indicators will turn on). In this mode, the steps 1 – 5 represent the

sounds in the order of their priority: 1-CH, 2-OH, 3-G1, 4-G2, 5-G3. Just press on

the needed step to trigger/play it.