- ページ 9

エクステンダー AVPro Edge AC-EX70-UHD-KITのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AVPro Edge AC-EX70-UHD-KIT 19 ページ。 Ultra slim 4k hdmi via hdbaset 70 meter extender
AVPro Edge AC-EX70-UHD-KIT にも：クイック・スタート・マニュアル (4 ページ)

ページを印刷する

Receiver Overview

Indicator Troubleshooting Lights - Receiver

POWER - On the back by power HDBaseT RJ45 port:

that the power is connected. There are only two states for light:

· Light Is On = Power supply is connected and functioning.

· Light Is Off = Power supply is not connected or there is no power present. In order to have

power, check the power supply, USP, Outlet, etc.

STATUS - On front by HDMI Port: (Blue) This indicator shows that the HDMI

source is connected. The states are:

· Light Is On (Solid) = Sync w/ HDMI source is correct and solid.

· Light Is Flashing = The light flashes during the sync process. If it is flashing continuously, a

picture may not be present.

If the BLUE HDMI SIGNAL LIGHT is flashing, check the following:

· The source. Plug it directly into the display to be sure it's functioning properly.

· Try a longer HDMI cable. Some HDMI cables do not sync well at shorter lengths, a 2 meter

minimum is recommended per HDMI Specifications.

· Set the EDID to state #1 (See Page[s] 12).

· Contact AVProEdge if these suggestions do not work.

HDBaseT

48V Power

IR IN

IR OUT

I-PASS

RS-232

Power LED

RS-232 Operation

Mode Switch

HDMI Out put

HDMI Signal

Indicator LED

(Red)

This is an indicator