AVPro Edge AC-EX70-UHD-KIT 사용자 설명서 - 페이지 9
{카테고리_이름} AVPro Edge AC-EX70-UHD-KIT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVPro Edge AC-EX70-UHD-KIT 19 페이지. Ultra slim 4k hdmi via hdbaset 70 meter extender
AVPro Edge AC-EX70-UHD-KIT에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지)
페이지 인쇄
Receiver Overview
Indicator Troubleshooting Lights - Receiver
POWER - On the back by power HDBaseT RJ45 port:
that the power is connected. There are only two states for light:
· Light Is On = Power supply is connected and functioning.
· Light Is Off = Power supply is not connected or there is no power present. In order to have
power, check the power supply, USP, Outlet, etc.
STATUS - On front by HDMI Port: (Blue) This indicator shows that the HDMI
source is connected. The states are:
· Light Is On (Solid) = Sync w/ HDMI source is correct and solid.
· Light Is Flashing = The light flashes during the sync process. If it is flashing continuously, a
picture may not be present.
If the BLUE HDMI SIGNAL LIGHT is flashing, check the following:
· The source. Plug it directly into the display to be sure it's functioning properly.
· Try a longer HDMI cable. Some HDMI cables do not sync well at shorter lengths, a 2 meter
minimum is recommended per HDMI Specifications.
· Set the EDID to state #1 (See Page[s] 12).
· Contact AVProEdge if these suggestions do not work.
HDBaseT
48V Power
IR IN
IR OUT
I-PASS
RS-232
Power LED
RS-232 Operation
Mode Switch
HDMI Out put
HDMI Signal
Indicator LED
(Red)
This is an indicator
9