- ページ 2

エクステンダー AVPro Edge AC-EXO-444-KITのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。AVPro Edge AC-EXO-444-KIT 4 ページ。 4k hdmi extender via optical fiber; up to 2 kilometer

ページを印刷する

Setup of the Transmitter:

IR Mode Slide Switch: (On Front) This is used to select a

preferred IR Mode

There are two modes:

1. IR-EYE - The IR Input will be configured to operate with

an IR Receiver Eye (Default)

2. I-PASS – The IR Input will be configured to safely oper-

ate with a direct connection

from a control system using a mono or stereo 3.5mm

cable. It's protected @ 3v-20v.

Using the Setting Button: The setting button can be pressed in different combinations

based on what is needed. The status light on the front will flash based on the selection.

The selections are in series, meaning, for example, if you are on selection 5 you can come

back later and press it again to move you to 6, 7, 8, 1, 2, etc... The SETTING BUTTON is located

front of the transmitter next to the micro USB port. The indicator light is next to the

button.

Installation of the Extenders and connection order:

Plug in the provided orange 2 pin power connector into both the

transmitter and receiver. Both must be powered for the system to func-

tion.

Ensure the fiber is terminated with LC SFP connectors.

The transmitter and receiver will have LC SFP ports. Plug the fiber

from the Transmitter to the Receiver.

The Receiver has an HDMI output. Connect this to the input of the

display with an 18Gbps HDMI cable.

The Transmitter has an HDMI input. Connect this to the output of

the source with an 18Gbps HDMI cable.

Connection Diagram

Fiber Optic

HDMI