- ページ 2

スイッチ AVPro Edge AC-CX42-AUHDのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。AVPro Edge AC-CX42-AUHD 7 ページ。

Front Panel Control and commands:

Buttons:

1. "HDBT Output Select" button - Toggles the active source for HDBT OUTPUT

2. "HDMI Output Select" button- Toggles the active source for HDMI Output

Button Commands:

Enable/Disable "Auto-Switching" - Simply PRESS & HOLD the OUTPUT SELECT button for 4

seconds to toggle "Auto-Switching"

1. When the LED is flashing "Auto-Switching" is enabled.

2. You can enable only one output to auto switch, or both - when both are

enabled, they will be mirrored.

• EDID is ideally set from the Web Interface, but can be set from the front panel (will be

walked through later in the guide)

To connect to the Matrix Switch and access the Web interface:

1. Connect the LAN port on the rear of the Matrix Switch into an active access

point or router

2. Make sure your computer is on the same network

3. Open any web browser and type in the IP address of the Matrix Switch. *NOTE

- The default IP address is: 192.168.001.239