- ページ 4

レンジ CPG 351SRCPG36NLのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CPG 351SRCPG36NL 9 ページ。 Countertop step-up ranges

User Manual

351SRCPG12NL | 351SRCPG24NL | 351SRCPG36NL

Installation Instructions

NOTE: Installation must be performed by a licensed service technician.

1 . Choose a location under a ventilation hood, see "Exhaust System" for more details. Also ensure that

the unit will maintain the proper clearances as shown the spec table above.

2 . Screw legs into the permanently fastened nuts on the four corners of the unit and tighten by hand.

Level the unit by turning the adjustment screw at the bottom of each leg. Do not slide unit with

legs mounted, lift if necessary to move unit.

3 . There must be adequate clearance for removal of the front panel. All major parts except the

burners are removable through the front if the gas line is disconnected.

1 . Ensure gas supply and gas type, as shown on unit nameplate, match. The nameplate is located on

the side panel.

24" Step-Up Countertop Range/Hot Plate

Lancaster, PA

4003027

2 . Unit installation must conform with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, the

National Gas Installation Code, CSA‐B149.1, or the Propane Installation Code, CSA‐B149.2 as

applicable and in accordance with local codes.

3 . Use pipe threading compound or tape to seal all gas connections. Pipe threading compound must

be resistant to the action of liquefied petroleum gases.

4 . DO NOT use an open flame to check for leaks. Check all gas piping for leaks with a soap and water

solution before operating unit.

w/ 4 High-Output Burners

Item: 351SRCPG24NL

Gas Type: Natural BTU: 120,000

Ori ce Size: #43

Manifold Pressure: 6" WC

Conforms to ANSI STD

Serial #:

Z83.11b-2009 (R2011)

Conforms to CSA STD

1.8b-2009 (R2011)

Intended for commercial use only.

NSF Tested by ETL

MADE IN CHINA