- ページ 4

計測機器 Abaxis VetScan HM5のPDF クイック・リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Abaxis VetScan HM5 17 ページ。 Hematology analyzer
Abaxis VetScan HM5 にも：インストレーション・マニュアル (1 ページ), インストレーション・インストラクション (2 ページ), クイック・リファレンス・マニュアル (19 ページ)

Connect the reagent pack as follows.

• Open the plastic bag located in the accessory box, and take out the six

color-coded reagent tubes and caps with drop-down tubes.

• Attach the supplied connector

tubing kit to the instrument,

as shown.

Attach the 2" tubing to the

stainless steel hose barbs

• Open the reagent pack box. Open each reagent container (lyse, lyse 2, rinse, cleaner,

and diluent) by unscrewing the container caps and piercing the bottle top seals.

• Re-cap each container using the bottle cap with the appropriate color-coded connec-

tor and drop-down tube.

• Flip diluent canister 180 degrees prevent reagent errors by ensuring that tubes are

not kinked when the box lid is closed.

• Connect each color tube to its matching color outlet. The connectors should

snap into each other when properly connected.

• Connect waste bottle.

Initialization of the HM5

• Connect Power Supply.

• Install paper into the built in printer.

• Turn on the analyzer by using the power switch on the upper left of its rear panel.

• The analyzer then displays several screens while it runs its software start-up procedure.

• Touch Measure, then touch Run.

• When prompted, touch OK to run a blank. ( Also see "Running a blank").

• The analyzer then initializes its pneumatic system and runs a blank measurement.

Attach the male

connector to the

reagent tubing

Snap the male connector into the

female connector