- ページ 8

電動工具 CPT CPDP-104のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。CPT CPDP-104 10 ページ。 Circle guide for drill press

After preparing the material you can proceed to setting up the Circle Guide and Drill Press.

Step 1:

Start by releasing the Alignment Pin and loosening the Lock-Down Bolt.

Step 2:

Move the Slide Plate away from the drill bit until it is stopped by the Lock-Down Bolt.

Step 3:

Insert the desired drill bit into the Drill Press.

Step 4:

Attach the desired Degree Gear by first placing the material onto the Center Pin using 1/8"

(English) or 3mm (Metric) hole (bottom of material facing up). Place double-sided tape on smooth

side of Degree Gear and then place onto material using the Center Pin (gears facing up).

NOTE: You can also mount using screw holes in Degree Gear instead of double-sided tape.

Step 5:

Lift material off the Center Pin and place aside.

Step 6:

Place the Rotation Plate on top of the Slide Plate using Center Pin and ensure it seats into position.

Step 7:

Now place material back onto the Center Pin with Degree Gear facing down. Ensure the Degree

Gear seats into the designated hole in the Rotation Plate.

Step 8:

Move the Slide Plate into desired position in order to set the radial distance. If using a set

measurement, insert the Alignment Pin into set measurement position and then tighten the Lock-

Down Bolt. If not using a set measurement, simply tighten the Lock-Down Bolt at current position.

Step 9:

Insert the Rotation Alignment Pin into the Rotation Plate and lock into the Degree Gear slot.

Step 10:

Turn on Drill Press and proceed to drilling a hole. Release the Rotation Alignment Pin and rotate

material when drill bit is raised. Lock into next Degree Gear slot and drill another hole. Continue

this process to drill holes in a circular pattern at the current radial distance. Repeat steps as

needed.

Drilling Holes in Material (with Degree Gears)