CPT CPDP-104 Інструкція з монтажу Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Електроінструмент CPT CPDP-104. CPT CPDP-104 10 сторінок. Circle guide for drill press
Друкувати сторінкуAfter preparing the material you can proceed to setting up the Circle Guide and Drill Press.
Step 1:
Start by releasing the Alignment Pin and loosening the Lock-Down Bolt.
Step 2:
Move the Slide Plate away from the drill bit until it is stopped by the Lock-Down Bolt.
Step 3:
Insert the desired drill bit into the Drill Press.
Step 4:
Attach the desired Degree Gear by first placing the material onto the Center Pin using 1/8"
(English) or 3mm (Metric) hole (bottom of material facing up). Place double-sided tape on smooth
side of Degree Gear and then place onto material using the Center Pin (gears facing up).
NOTE: You can also mount using screw holes in Degree Gear instead of double-sided tape.
Step 5:
Lift material off the Center Pin and place aside.
Step 6:
Place the Rotation Plate on top of the Slide Plate using Center Pin and ensure it seats into position.
Step 7:
Now place material back onto the Center Pin with Degree Gear facing down. Ensure the Degree
Gear seats into the designated hole in the Rotation Plate.
Step 8:
Move the Slide Plate into desired position in order to set the radial distance. If using a set
measurement, insert the Alignment Pin into set measurement position and then tighten the Lock-
Down Bolt. If not using a set measurement, simply tighten the Lock-Down Bolt at current position.
Step 9:
Insert the Rotation Alignment Pin into the Rotation Plate and lock into the Degree Gear slot.
Step 10:
Turn on Drill Press and proceed to drilling a hole. Release the Rotation Alignment Pin and rotate
material when drill bit is raised. Lock into next Degree Gear slot and drill another hole. Continue
this process to drill holes in a circular pattern at the current radial distance. Repeat steps as
needed.
Drilling Holes in Material (with Degree Gears)