- ページ 7

室内装飾品 DGS Retail APTE3のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。DGS Retail APTE3 8 ページ。 Produce table

ページを印刷する
DGS Retail APTE3 クイック・スタート・マニュアル
SET THE TABLE TOP AT REQUIRED ANGLE:
9
- Remove/ cut-off the zip ties that hold two support arms attached to side tubes.
- Lift the back of the top frame of table and swing down both left and right support arms.
- Depending on the required angle of the top, engage/ rest the appropriate cut-out on support
arms on short side tubes.
- Table top can be set/ adjusted at 0, 15, 25, and 35 degrees.
ASSEMBLE PLASTIC TOP PANEL:
10
- Place the plastic panel with magnetic strips on top of frame, ensure that front of panel
(portion without magnets) is located over front Z-channel and magnets rest on tubes.