DGS Retail APTE3 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} DGS Retail APTE3에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DGS Retail APTE3 8 페이지. Produce table

SET THE TABLE TOP AT REQUIRED ANGLE:

- Remove/ cut-off the zip ties that hold two support arms attached to side tubes.

- Lift the back of the top frame of table and swing down both left and right support arms.

- Depending on the required angle of the top, engage/ rest the appropriate cut-out on support

arms on short side tubes.

- Table top can be set/ adjusted at 0, 15, 25, and 35 degrees.

ASSEMBLE PLASTIC TOP PANEL:

- Place the plastic panel with magnetic strips on top of frame, ensure that front of panel

(portion without magnets) is located over front Z-channel and magnets rest on tubes.