- ページ 8

防犯カメラ Avtech DGC1105AのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Avtech DGC1105A 8 ページ。 Ir bullet camera

ページを印刷する

FLICKER

(automatic

exposure)

BLC

AGC

LSC

SPECIAL

PRIVACY ZONE

HLC

EFFECT

COLOR GAIN

COLOR HUE

SHARPNESS

CONTRAST

BRIGHT OFF.

MIRROR

FLIP

SYSTEM

CAMERA ID

ID DISP.

NAME DISP.

LANGUAGE

FACTORY INIT

EXIT

SAVE & EXIT

EXIT

DESCRIPTION

Enable this function to fix the flicker situation.

OFF / 50HZ /

60HZ

Adjust the image to compensate for an area that is overpowered by

0 ~ 16

brightness because of excessive light. The image will be properly

exposed for clearness.

Note: This function is available only in the day mode.

Set the level of Auto Gain Control to detect and enhance the image

1 ~ 5

signals when the light condition is poor.

The higher the value, the stronger the signals will be enhanced, and

the more noise the image will get.

Enable or disable Lens Shading Correction to correct the

ON / OFF

phenomenon of vignetting when the focal length is short.

Select AREA1 or AREA2 to show a predefined area for masking. To

AREA SEL.

move and change the area, please go to SX / EX / SY / EY.

MASK PAT.

Select the color to mask: black / gray / white. Select OFF to disable

area masking.

Extend / narrow the current area from the left side.

Extend / narrow the current area from the right side.

Extend / narrow the current area from the top.

Extend / narrow the current area from the bottom.

HLC

HLC (high light compensation) is used to suppress strong backlight

for clearer images. A grey mask will be covered on the source of the

strong light.

Choose ON and click

function.

The screen will be divided into 16 areas. Move to the area you

want, and click

MASK VALUE

Set the darkness of the mask.

The more the value, the lighter the grey you'll get. The less the

value, the darker the grey you'll get.

THRESHOLD

Set the level of light source which enables masking.

The more the value, the stronger the light source will trigger HLC;

the less the value, the lighter the light source will trigger HLC.

0 ~ 255

Set the level of color saturation.

The more the value, the more saturated the color will be, but the

more noise the image will get.

0 ~ 71

Set the level of hue.

0 ~ 255

Set the level of sharpness to enhance the clarity of image detail by

adjusting the aperture and sharpening the edges.

The more the value, the sharper the image will be.

0 ~ 255

Set the level of contrast.

The more the value, the more the contrast level of the image will be.

-128 ~ 127

Set the level to compensate the brightness of the image if needed.

The more the value, the brighter the image will be.

OFF / ON

Enable to turn the images horizontally based on your installation

situation when necessary.

OFF / ON

Enable to flip the image 180° when necessary.

0 ~ 255

Set the camera ID.

OFF / ON

Enable or disable the display of the camera ID.

OFF / ON

This function has no use.

ENG / 中文

Select the language of the menu: English / Simplified Chinese.

OFF / ON

Enable to restore the camera parameters to factory default values.

The camera image will flash once when the reset is done.

Save all the changes you've made in each menu and exit.

Exit without saving.



(ENTER) to select the areas for this



(ENTER) to make X to O.