ソフトウェア Allied Telesis AR400 SeriesのPDF 設定方法をオンラインで閲覧またはダウンロードできます。Allied Telesis AR400 Series 6 ページ。 How to set up pppoe between a linux client and access concentrator
Allied Telesis AR400 Series にも：トラブルシューティングマニュアル (8 ページ), トラブルシューティング (5 ページ), クイック・インストール・マニュアル (8 ページ), クイック・インストール・マニュアル (12 ページ), 安全情報マニュアル (18 ページ), ハウツー (8 ページ)

AlliedWare™ OS

Configure Dynamic Routing Over An L2TP Tunnel

How To |

Introduction

This How To Note shows an example of using a dynamic routing protocol over an L2TP

tunnel.

Running dynamic routing protocols over a secure Internet connection can be a complex

issue, with the possibility of intermittent connections causing routing problems.

OSPF (or BGP) are more connection-oriented than RIP and therefore are more susceptible

to problems caused by intermittent loss of connection between 'neighbours'. A neighbour

that may bounce up and down can cause havoc to the correct propagation of OSPF routing

information for a network.

The following example scenario is for setting up RIP over an L2TP tunnel. RIP is simpler and

has less overhead and control, so it provides a more robust setup as a dynamic routing

protocol over an L2TP tunnel.

Which products does it apply to?

This Note applies to the following Allied Telesis routers, running software version 2.6.1 or

later:

AR400 series

AR700 series

C613-16037-00 REV C