Allied Telesis AR400 Series Jak skonfigurować

Przeglądaj online lub pobierz pdf Jak skonfigurować dla Oprogramowanie Allied Telesis AR400 Series. Allied Telesis AR400 Series 6 stron. How to set up pppoe between a linux client and access concentrator
Również dla Allied Telesis AR400 Series: Instrukcja rozwiązywania problemów (8 strony), Rozwiązywanie problemów (5 strony), Podręcznik szybkiej instalacji (8 strony), Podręcznik szybkiej instalacji (12 strony), Podręcznik z informacjami dotyczącymi bezpieczeństwa (18 strony), Jak to zrobić (8 strony)

AlliedWare™ OS

Configure Dynamic Routing Over An L2TP Tunnel

How To |

Introduction

This How To Note shows an example of using a dynamic routing protocol over an L2TP

tunnel.

Running dynamic routing protocols over a secure Internet connection can be a complex

issue, with the possibility of intermittent connections causing routing problems.

OSPF (or BGP) are more connection-oriented than RIP and therefore are more susceptible

to problems caused by intermittent loss of connection between 'neighbours'. A neighbour

that may bounce up and down can cause havoc to the correct propagation of OSPF routing

information for a network.

The following example scenario is for setting up RIP over an L2TP tunnel. RIP is simpler and

has less overhead and control, so it provides a more robust setup as a dynamic routing

protocol over an L2TP tunnel.

Which products does it apply to?

This Note applies to the following Allied Telesis routers, running software version 2.6.1 or

later:

AR400 series

AR700 series

C613-16037-00 REV C