Allied Telesis AR400 Series Jak skonfigurować - Strona 2

Przeglądaj online lub pobierz pdf Jak skonfigurować dla Oprogramowanie Allied Telesis AR400 Series. Allied Telesis AR400 Series 6 stron. How to set up pppoe between a linux client and access concentrator
Również dla Allied Telesis AR400 Series: Instrukcja rozwiązywania problemów (8 strony), Rozwiązywanie problemów (5 strony), Podręcznik szybkiej instalacji (8 strony), Podręcznik szybkiej instalacji (12 strony), Podręcznik z informacjami dotyczącymi bezpieczeństwa (18 strony), Jak to zrobić (8 strony)

Related How To Notes

You may also find the following How To Notes useful:

How To Configure Remote L2TP Tunnels

How To Configure Allied Telesis and Cisco Routers To Interoperate Over L2TP

How To Notes are available from www.alliedtelesis.com/resources/literature/howto.aspx.

An example scenario for RIP over L2TP

Our example uses two office sites that are connected via a WAN connection over the

Internet using an L2TP tunnel for security.

The setup (shown below) shows the 'Central office' and 'Remote office' routers connected,

in this case, back to back via their Ethernet interfaces (this would likely be the remote WAN

connection across the Internet, with perhaps static IP assignment from the ISPs).

Page 2 | AlliedWare™ OS How To Note: Dynamic Routing over L2TP

Central office router

192.168.1.1

RIP propogates

VLAN OSPF

PPP0 over

routes over

L2TP tunnel

to remote router

192.168.2.1

Remote office router

VLAN 2 IP=222.222.2.1

OSPF used on

local VLAN

networks

ETH0

X PC

HUB

POWER

Eth0 IP=10.10.10.1

WAN

Eth0 IP=10.10.10.2

X PC

HUB

POWER

ETH0

OSPF used on

local VLAN

networks

VLAN 2 IP=200.200.2.1

An example scenario for RIP over L2TP

VLAN 1 IP=222.222.1.1

VLAN 1 IP=200.200.1.1

rip-l2tp.eps