- ページ 21

サーバー Dell PowerEdge 860のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge 860 37 ページ。 Sas/raid controller installation
Dell PowerEdge 860 にも：情報更新 (14 ページ), インストールマニュアル (28 ページ), 取付説明書 (7 ページ)

ページを印刷する

hard drive cage

NOTICE:

When the hard drive is not in the computer, store it in a protective antistatic package (see "Protecting Against Electrostatic Discharge"

in the safety instructions shipped with your computer).

Replacing the Hard Drive

1. Remove the new drive from its packaging.

NOTE:

Save the original packaging for storing or shipping the hard drive.

NOTICE:

Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the connector.

2. Place the hard drive in the hard drive cage and press it down until it snaps into place.

3. Push down the hard drive assembly in place by aligning the hard drive connector with the system board connector.

4. Replace the two screws securing the hard drive assembly to the system board.

5. Replace the system board (see

6. Slide the battery into the battery bay, until it clicks into place.

NOTICE:

Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may

result in damage to the computer.

7. Install the operating system for your computer, as needed (see "Restoring Your Operating System" in your Setup Guide).

8. Install the drivers and utilities for your computer, as needed (see "Reinstalling Drivers and Utilities" in your Setup Guide).

Back to Contents Page

hard drive

"Replacing the System

Board).