- ページ 9

ストレージ Dell PowerEdge 5160のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge 5160 28 ページ。 Installing the external drive bay
Dell PowerEdge 5160 にも：インストレーション・マニュアル (42 ページ), インストレーション・マニュアル (20 ページ), 更新マニュアル (8 ページ), 情報更新 (8 ページ), ユーザーマニュアル (42 ページ), ラックの設置 (34 ページ), ハードウェア・インストール・マニュアル (40 ページ), インストレーション・マニュアル (36 ページ)

support.dell.com

WARNING: Never pull more than one system out of the rack on its slide

assemblies at one time. The weight of more than one extended system

could cause the rack to tip over and injure someone.

The stabilizer feet help prevent the possibility of the rack tipping over when a

system or other components are pulled out of the rack far enough so that the slide

assemblies are fully extended. Refer to the Dell PowerEdge Rack-Mountable

Solutions Installation Guide provided with the rack for instructions on installing the

stabilizer feet.

Recommended Tools

To install the tower kit, you need the following tools:

•

A #2 Phillips screwdriver

•

A flat-blade screwdriver

To install a tower kit, perform these steps (see the following subsections for detailed

instructions):

Shut down and turn off the system.

Remove the rack's front and rear doors.

Remove the cable management arm.

Remove the cable tray.

Remove the system from the rack.

Replace the rack doors.

7 .

Install the rubber feet.

Remove the front bezel.

Reorient the drives.

10. Reorient the system badge.

11. Replace the front bezel.

12. Attach the cables and turn the system on.

It is usually best to perform this installation at a time when there are no users on the

system. Shut down all application programs running on the server and turn off the

system.

Dell PowerEdge 4x00 and 6300 Systems Tower Installation Guide

1-3