- ページ 13

ストレージ Dell PowerVault 201SのPDF 交換取扱説明書をオンラインで閲覧またはダウンロードできます。Dell PowerVault 201S 14 ページ。 Dell powervault 20xs storage systems enclosure services expander module installation
Dell PowerVault 201S にも：ラック設置マニュアル (26 ページ), マニュアル (9 ページ), 更新 (4 ページ), 構成 (2 ページ), インストレーション・マニュアル (48 ページ)

ページを印刷する

Install the Hard-Disk Drives

NOTICE: Install the hard-disk drives in the same drive bays from

which they were removed.

NOTICE: Handle the hard-disk drives with care. The carriers provide

some protection, but the hard-disk drives can be damaged by rough

handling. When installing hard-disk drives, use gentle pressure to

slide them in the drive bays. Insert them slowly; never use force.

To install the hard-disk drives, perform the following steps:

1. Carefully slide the hard-disk drive into the bay (see Figure 13). When the

hard-disk drive is almost all the way into the bay, the carrier handle flips up.

Figure 13. Installing a SCSI Hard-Disk Drive (System Shown with a

Swing-out Lock Bar)

2. Close the handle to draw the drive carrier into the bay and lock the drive in

place.

3. Repeat steps 1 and 2 to install the remaining hard-disk drives.

4. For a storage system with a silver swing-out lock bar, raise the lock bar to

the lock position. The lock bar slips down into a detent. This holds the lock

bar in the lock position.

If the storage system is in a stand-alone configuration, swing the lock bar

to the left into the lock position. The lock bar slips to the right into a detent.

This holds the lock bar in the lock position.

For a storage system with a black, removable lock bar, place the left end of

the lock bar into its hole in the left side of the front panel. Then, align the

lock bar with the locking mechanism by the keylock (see Figure 14).

Dell PowerVault 2xxS Storage Systems SCSI Backplane Board Replacement Instructions