- ページ 7
ストレージ Dell PowerVault 224FのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault 224F 24 ページ。 Dell powervault 110t dlt vs160 tape drive - user's guide
Dell PowerVault 224F にも： ユーザーマニュアル (23 ページ), ユーザーマニュアル (39 ページ)
ページを印刷する
support.dell.com
Installing the RAID Controller
This section describes how to install the controller into Dell PowerVault 660F and
224F storage systems. See Figure 1-1 for a view of the controller, LED indicators, and
connectors.
Figure 1-1. Dell Fibre Disk RAID Controller
Before You Begin
The following items are required to complete this installation:
•
Dell PowerVault 660F or 224F storage system(s)
•
Cables to interconnect the PowerVault 660F storage system and up to seven
additional Dell PowerVault 224F storage systems
•
Cables to connect the system and the controller
•
A Phillips-head screwdriver to loosen and tighten the screws
•
A minimum of three fibre drives for RAID 3 and RAID 5 configurations
•
A Fibre Channel host bus adapter (HBA); use only the Qlogic QLA2200 Fibre
Channel HBA, or later Dell-supported HBA, with the controller
NOTE: If you are installing a dual-active configuration, both controllers must have the
same physical configuration, the same amount of memory, and the same firmware
version and type.
DB 9
connector
LED indicators
Upgrade Installation Guide
HSSDC
connector
1-3