Dell PowerVault 224F 설치 매뉴얼 - 페이지 7
{카테고리_이름} Dell PowerVault 224F에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault 224F 24 페이지. Dell powervault 110t dlt vs160 tape drive - user's guide
Dell PowerVault 224F에 대해서도 마찬가지입니다: 사용자 설명서 (23 페이지), 사용자 설명서 (39 페이지)
페이지 인쇄
support.dell.com
Installing the RAID Controller
This section describes how to install the controller into Dell PowerVault 660F and
224F storage systems. See Figure 1-1 for a view of the controller, LED indicators, and
connectors.
Figure 1-1. Dell Fibre Disk RAID Controller
Before You Begin
The following items are required to complete this installation:
•
Dell PowerVault 660F or 224F storage system(s)
•
Cables to interconnect the PowerVault 660F storage system and up to seven
additional Dell PowerVault 224F storage systems
•
Cables to connect the system and the controller
•
A Phillips-head screwdriver to loosen and tighten the screws
•
A minimum of three fibre drives for RAID 3 and RAID 5 configurations
•
A Fibre Channel host bus adapter (HBA); use only the Qlogic QLA2200 Fibre
Channel HBA, or later Dell-supported HBA, with the controller
NOTE: If you are installing a dual-active configuration, both controllers must have the
same physical configuration, the same amount of memory, and the same firmware
version and type.
DB 9
connector
LED indicators
Upgrade Installation Guide
HSSDC
connector
1-3